Licensed and insured Utah S350 Plumbing Contractor Water heaters only since 2009 Booking today
Ogden and Northern Utah

New build, remodel,or moving it somewhere better.

Fresh installs where there was nothing before, or where the heater needs to end up in a different place than the last one.

Start here

What is it doing?

Pick the closest. Takes about thirty seconds.

We come back with what actually failed, whether it is a part or the tank, and what each option costs. No visit needed to get that far.

Or call (801) 643-5784

Repair first

We do not condemn a water heater because of its birthday. Many have years left with an anode rod, a valve or a flush.

Flat upfront pricing

Quoted and approved before anything starts. No hourly meter, no line items added while we are in there.

Same day capable

A person answers the phone. Real arrival windows, and parts on the truck for the common faults.

What it is probably doing

An installation is not the same job as a replacement. A replacement has a template to follow, because something was already there and it worked. An installation has to be designed: where it goes, how it vents, how it drains, and what the household will actually need from it.

That makes sizing and placement the whole job. Get those right and the unit is almost incidental. Get them wrong and you have an expensive machine in a bad spot for the next fifteen years.

A newly installed gas water heater with expansion tank, venting and a drain pan
The serial number comes first. It tells us the build year, which is the only honest way to know the age of a heater. Everything after that is tracing the symptom.
Design it properly

New build

Sizing from the plans and the household, not from whatever fits the space.

Right timing

Remodel or basement finish

Relocating the heater is easiest while walls are open. Worth doing now.

Depends on the route

Moving the heater to free up space

Doable. Venting and drainage decide how far it can move.

Worth modelling

Adding a second unit

Large homes with long runs sometimes do better with two units than one big one.

Price the whole job

Converting fuel type

Gas to electric or the reverse changes venting, circuits and cost. We price the whole job.

Placement decides it

Heat pump water heater

Excellent efficiency, but it needs air volume and it makes noise. Placement matters more than usual.

Tell us the symptom. We will tell you which one it is.

Get an honest diagnosis
Or call (801) 643-5784

The honest diagnosis

The same four steps on every call, whether it turns into a two hundred dollar repair or nothing at all.

A technician checking a residential water heater against a tablet in a utility room
01

Call or send the details

Age, symptom, and what it is doing. A person answers, not a queue.

Most questions answered on the call
02

We diagnose it

Serial read, symptom traced, tank checked. About twenty minutes.

You find out what actually failed
03

You get both numbers

Repair cost and replacement cost, side by side, in writing, with our recommendation.

Flat price, approved before we start
04

We do the work

Parts on the truck for common repairs. Replacement stock available same day.

Price does not move

If we recommend a repair and the tank fails within a year, the repair comes off the replacement

We would rather be wrong at our own expense than sell you a water heater you did not need. Every install is warranted on parts and labour.

What it costs

Published, because you should be able to work out roughly where you stand before anyone comes to the house.

  • Electric water heater $1,250 to $2,400
  • Gas water heater $2,100 to $3,250
  • Power vent water heater $2,900 to $3,400
  • Tankless installation $3,500 to $5,500
  • Expansion tank $200 to $300
9x A repair starts at $225. Replacing a gas water heater starts at $2,100. That gap is the entire reason we diagnose before we quote.

Where you land in the range

The low end is a thermocouple or a thermostat. The high end is a gas control valve, or work that needs the tank drained and a fitting cut out.

We tell you which end you are on before the work starts, and the price does not move after that.

Sediment laden water draining from a water heater into a bucket
What $150 buys. Sediment out of a tank that had never been flushed. The cheapest line on the list, and the one that keeps a heater off the rest of it.

We will tell you which of these numbers applies to your house.

Get my number
Or call (801) 643-5784
Cutaway diagram of a residential tank water heater Six labelled components: anode rod, dip tube, temperature and pressure relief valve, sediment layer, drain valve, and thermostat with gas control. 1 2 3 4 5 6
Standard 40 to 50 gallon tank, cutaway. Orange marks the sediment layer, the most common cause of a heater that sounds like it is failing but is not.
What actually fails

Five of these six are parts. One is the tank.

  • 1
    Anode rod

    Corrodes so the steel tank does not. Spent by roughly year five, and almost nobody replaces it.

  • 2
    Dip tube

    Carries cold water to the bottom. When it cracks, cold mixes at the top and the shower turns lukewarm early.

  • 3
    Temperature and pressure valve

    A safety device. If it weeps it is usually the valve or the expansion tank pressure, not the heater.

  • 4
    Sediment layer

    Hard water leaves scale on the tank floor, insulating the burner from the water. That is the rumbling.

  • 5
    Drain valve

    Prone to seeping once it has been opened after years of neglect.

  • 6
    Thermostat and gas control

    Governs burner and pilot. The usual reason a pilot will not hold.

Questions we get asked

Do you install water heaters in new builds?

Yes. We size from the plans and the household rather than fitting whatever the space allows, and we would rather be involved before the space is finalised than after.

Can you move my water heater to a different location?

Usually. The limits are venting and drainage, not the plumbing. A move that puts it further from an exterior wall or a drain gets more involved, and we will tell you what it costs before committing to it.

What is a power vent water heater and do I need one?

It uses a fan to push exhaust out horizontally instead of relying on a vertical flue. You need one when there is no usable chimney or the unit sits somewhere a natural draft will not work. They run $2,900 to $3,400 fitted.

Are heat pump water heaters worth it in Utah?

They are very efficient, but they need a decent volume of air around them and they are not silent. In an open basement they work well. In a small closet they underperform and annoy people. Placement decides it.

Do you handle permits and inspection?

Yes. Installs are done to code, with the venting, expansion tank, pan and strapping that inspection actually looks at.

How do I know what size to install?

Household size, how many fixtures run at once, fuel type and space. Two to three people are usually fine on forty gallons, four to five on fifty, larger households need capacity or faster recovery. We size it rather than guess it.

Tell us what it is doing

Three questions. We will tell you whether this is a part or a tank, and roughly what each one costs, before anybody schedules anything.

Fastest way (801) 643-5784

Mon to Sat, 7am to 7pm. Emergency service available.

Response

Most repair calls are seen the same day. Replacements are usually next day, sooner if the tank is leaking.

What you get back

What most likely failed, whether it is a part or the tank, and what each option costs. In writing, before anything is scheduled.

Where we work

Based in Ogden, UT. We come to you across nineteen cities in Weber, Davis and Morgan County.

What is it doing?
Pick the closest.
Optional. Noises, when it started, what you have already tried.

No obligation, and no in home visit needed to get a straight answer. If it sounds like a repair on the phone, we will say so.

Find out what is actually wrong with it.

Tell us the age, the symptom and what it is doing. We will tell you whether this is a part or a tank, and what each one costs, before anybody schedules anything.

Speak to a technician (801) 643-5784

Mon to Sat, 7am to 7pm. Emergency service available.

Call (801) 643-5784 Get a diagnosis